Panasonic HDC-SDT750PP Operating Instructions Manual page 26

I d"t_1,3 F Jr_
f
This unit cannot be
operated though it is
turned on.
This unit does not
operate normally.
em other than the
uched one is
elected.
/'The remote control
does not function.
\
/The remaining time
indication or the
elapsed time
indication is not
shown.
\
f
The unit arbitrarily
stops recording.
J
AUto focus function
oes not work.
J
• Remove the battery or AC adaptor, wait about
1 minute and then reconnect the battery 0rAC
adaptor. Then about 1 minute later, turn on the u _it
again. (Conducting the above operation while the
media is being accessed may damage the data on
the media.)
• If normal operation is still not restored, detach the
power connected, and contact consumer support.
(-) 170. 171,172)
• Calibrate the touch screen (-) 47)
• [REMOTE CONTROL] of the [SETUP] is [OFF].
(-) 49)
• The button-type battery of the remote control may
have run out. Replace it with a new button-type
battery. (-) 49)
• [DISPLAY] of the [SETUP] is [OFF]. (-) 42)
• Use an SD card that can be used for motion picture
recording. (-) 23)
• The recordable time may have shortened due to the
deterioration of the data writing speed or [epeated
recording and deletion. Using the unit. format the SD
card. (-) 47)
• If [AGS] is [ON]. record in the normal horizontal
position or set [AGS] to [OFF]. (-) 75)
• Switch to Intelligent Auto Mode.
• If you are trying to record a scene which is hard to
bring into focus in Auto Focus Mode. use the Manual
Focus Mode to adjust the focus. (-) 36, 89)
144
VQT3B18