Implement Hitch Wiring - Walker DB6660 Owner's Manual

Assembly Instructions

Implement Hitch Wiring

1. Drill five (5) 13/64 in. (5 mm) diameter holes in
the tractor, two in the FSC lever and three in the
body, as shown in the illustration.
Drill Holes for Implement Hitch Wiring
2. Attach the toggle switch mounting bracket on
the FSC lever using two (2) 10-24 x 1/2 in. bolts
and Keps nuts. Connect the green ground wire
from the actuator wiring harness to one of the
bolts of the switch mounting bracket.
Mounting
Bracket
Attach Toggle Switch Mounting Bracket
3. Install the wiring harness to the tractor body us-
ing the three wiring clamps, three 10-24 x 3/8 in.
bolts and Keps nuts.
20
Wiring
Harness
Ground
Wire
4. Attach the toggle switch to the mounting brack-
et, placing the switch terminals toward the front
of the mower.
Mounting Bracket
Switch
Terminals
Attach Wiring Harness and Toggle Switch
5. On Models MC, MDD/MDG, and MT, connect
the harness red wire to the load side of the cir-
cuit breaker mounted on the bracket behind the
battery.
Circuit Breaker
Connect Harness Wire to Circuit Breaker
IMPORTANT: For all 1987-1997 Model MC
tractors (with Kohler Magnum engine), connect
the harness red wire to the free connector of the
PTO clutch switch red wire. Refer to Implement
Hitch Wiring Diagram illustration.
Wiring Clamps
Harness
Red Wire