Sony Playstation 3 Instruction Manual page 5

3
Attach the top cover.
4
Insert the navigation controller into the navigation controller holder
(figure  ).
Open the navigation controller holder cover.
ˎ
Position the navigation controller so that the two small holes at the bottom of the
ˎ
casing line up with the holder's pegs. Holding the navigation controller
diagonally, insert the top of it into the holder and then push the bottom down so
it is firmly seated onto the holder's pegs.
5
Close the navigation controller holder cover.
Using the sharp shooter
1
To adjust the length of the stock, press the release button and pull the stock
out or push it in to your desired length (figure  ). When you pull the stock
out, listen for the clicks that indicate the secure stop locations.
2
Use either hand to operate the navigation controller and the free hand
to operate the T button trigger (figure  ). Wear the motion controller's
wrist strap around the hand which you are using to operate the navigation
controller.
(Optional) To lock the Move button trigger so it cannot be pressed, slide the
Safety Lock located on either side of the sharp shooter to the down position.
(The button on the other side should automatically slide to the down
position) To unlock the Move button trigger, return the Safety Lock to the up
position.
3
For information about in-game button control, please consult your game
manual.
Removing the motion and navigation controllers
1
Remove the navigation controller from the navigation controller holder
(figure  ).
Open the navigation controller holder cover.
ˎ
Push your finger through the hole in the underside of the holder to release the
ˎ
navigation controller.
Close the navigation controller holder cover.
ˎ
2
Remove the motion controller from the barrel guide.
Slide the RELEASE latch on both sides simultaneously to remove the top cover of
ˎ
the barrel guide.