Electronic
Display: Displays the following
lnformatfon;
A'. Remote Contro! power On/Off and Mode icons
B: Clock and Auto-Timer settings
C: Currant set temperature
D: Fan speed setting
Control Buttons
1, Power switch,
2, Mode
3, Fan Speed
4_ Energy Saver
5. Auto-Timer
6. Used to increase _k or decrease V temperature
settings in 1° Increments on the Celsius or
Fahrenheit scale° When adjust the Umer or timer
settings in 1 minute
7. Cancels currentTimer ON/OFF settings,
8, Lock _ prevents the remote control settings from
Inadvertently being changed,
9. Clock: Depress the button for 3 seconds in order
to set the clock. Press the increase or decrease
arrow to adjust the clock in 1 minute Intervals,
holding down the Increase or decrease arrow will
adjust the time In 10 minute intervals.
10. Used to activate the SLEEP program.
11, Toggle the LED backllght on/off,
12, Restore remote control default se_ngs.
Electronic
Display
To operatethe hand held remotecontrol w illrequire
two"AAA"Alka!ine batteries (included)_
Batteries should be replaced when=
a) No signal (beep) is heard when attempting to
program the main unit.
b) The main unit does not respond to a command
issued by the remote control.
Battery replacement;
1, Slide the rear cover on the remote in the direction
of the arrow° Continue pulling (gently) until the
cover separates completety from the unit.
2, insert (2) batteries (AAA) following the same
orientation (polarity) depicted inside the battery
chambero(+/-)
3, Re-Install rear cover.
4. if the remote control will not be used for extended
periods of time (vacations etc,), batteries should
be removed°
The remote operates within a range of 8 meters
(26 fL) from the receiver located Inside the main unit,
Any obstruction between the receiver and remote
may cause signal interference, limiting the ability to
program the main unit,