Advertisement
Available languages
Available languages
Your Room Alr Conditioner is designed to be
highly efficient In energy savings°
Follow these recommendations for greater efficiency,
1o Select thermostat setting that suits your
comfort needs and leave thermostat at that
chosen setting,
2, The filter Is very efflcfent In removing airborne
particles, Keep air _terclean°
Normally, filter
should be cleaned every 2 weeks. More
frequent cleaning may be necessary depending
on indoor air quality,
3. Use drapes, curtains, or shades to keep
direct sunlight from heating room, but DO NOT
obstruct the air conditioner. Allow air to circulate
around the unit without obstruction.
4.
5.
Start your air conditioner before outdoor air
becomes hot and uncomfortable. This avoids an
initial period of discomfort while unit is cooling
off the room,
When outdoor temperatures are cool enough,
use HIGH or LOW FAN only, This c{rculates
Indoor air, providing some cooling comfort, and
utilizes less electricity than when operating on a
cooling setting.
.......
17_ _/_t;ir_
_-_ r-__
-
%_1
To avoid the possibilityof personal
Injury, disconnect power to the unit
before installing or servicing,
Tools Needed for Installation
Screw Drivers:
Both Phli!tps and fiat head
Power Drill:
1/8 inch diameter drill bit
Pencil
Measuring Tape
Scissors
Carpenters Level
To avoid Installatlonloperatlon
difficulties,
read these Instructions
thoroughly,
Your Room Air Conditioner is designed for easy
installation in a single or double-hung window This
unit is NOT designed for vertical [slider type)
windows and/or through-the-waft applications
NOTE; Save the shipping carton and packing
materials for luture storage or transport of the unit
Remove from carton, the plastic bag containing the
fnsta]tation hardware kit necessary for the instaflation
of your air conditioner Please check the contents of
hardware kit against the corresponding model check
list, prior lo installationof the unit, See Fig 1
I
.
.
II I
i';
I
i
.
"
3/4"Screws (7)
U
1 SafetyLock (1)
mounting bracket
*Factory
lnsta/ted
on
(1)
somemodels,
heslve
L_
FoarnSeal(t)
Fig, I
S]deCudaln RH(1) ]
SideCurtain LH(1)
Advertisement
