Advertisement
Available languages
Available languages
LED DISPLAY:
Displays the following Information
independently;Set Temperature, Ambient Room
Temperature and Auto Timer On/Off settings.
'b
POWER: Turns unit On / Off.
mo_oB MODE; Allows you to scroll throughand select
_7 the desired operating mode; Cool a_., Dry ('-_r-,
Fan Only _
and "Auto I1_iio The selected
mode wiltbe denoted by the adjacent indicator
fight. *'Auto' is a pre.set factory program that
automatically defines the mode (Cool or Dry) and
fan speed based on the set temperature
_FAN
SPEED: Select from four diflerenlfen settings;
Low J_ , Medium _ , High ._ and Auto
duringCool and Fen Onty mode
Please note:
During 'Dry'mode the fan speed is automatically
defined+
::_jl_
ENERGY SAVER:
Automalicatly
cycles the fan on
• and off while the compressor is not in use
O/.r_
TEMP++/TIMER Control:
Used to increase 1_ or
decrease 4 the Temperature
setting tn 1_C / °F
increments and AutmTimsr
On!Oft settings in 30
minJlhr
increments
Note: This appliance at!owe you select the
temperature scale to be displayed in either "Celsius" or
Fahrenheir according to your prelerence
To change
the temperature scale displayed on the electronic
display, press both the "Tamp/Timer" adjust arrows
simultaneously
te alternate between "Celsius" &
"Fahrenheit"
;:_
CHECK FILTER : The adjacent Indicator light wfll
illuminateas a reminder to clean the aft conditioner
filter (see page 9) Once the filter has been
cleaned and replaced, depress the Check Filter
button in order to resume operation.
SLEEP MODE When
the currentset
activated,
temperatureIs gradualiy increasedover a one (1)
hour period then maintained for seven(7) hours.
Once the programis complete,the air conditioner
will resumeto it'sprevious set temperature (before
sleep mode was activated)+ This feature is meant
to be used duringthe night time hours to prevent
the room from getting too cold (while you sleep)
and results tn less compressor running time and
reduced energy consumption, Sleep mode may
be cancelled by depressing the Sleep Mode
button while the program Is runnfngo
Tamp/Timer
Control ''-
Check
Filter
Mode
l-
Selector
Energy J"
Sever
SW
LED
-DISPLAY
Auto
Timer
Sleep
Fan
"Speed
_ower
Bu_on
J'_ AUTO-TIMER=
Used to Initiate the Auto On and/or
AutoOff timer.
Whlle the Air Conditioner ls off (Auto-On):
I. Press the Auto-Timerbutton once andthe adjacent
Auto-On Indicator light'--'
wtllIlluminate.
2. Use the Tamp/Timer control cursors to select a
delayed On time of up to 24 hours.
3, Select the appropriate mode under which you want
the unit to operate (Auto-Coot-Dry-Fan Only)
4. Select the fan speed setting.
5, The time you selected wliI appear in the LED
dlsplayo.
Whtle the Air Conditioner fs on (Auto-Off);
t. Press the Auto-Timer button twice and the adjacent
Auto-Off indicatorlight JL wtllIlluminate.
2oUse the TemplTImer control cursorsto select a
delayed Oft'time of up to 24 hours.
3. The time you selected will appear tnthe LED display
The Auto On and Auto Oft timer can operate dudng the
same program by defining the Auto-Off parameters
immediately
after the Auto On parameters
The Auto-Timer
may be cancelled at any time by turning
7
the unit OnlOft,
Advertisement
