Troubleshooting Guide - Danby Designer DAC6003D Use And Care Manual

Hide thumbs Also See for Designer DAC6003D:
Table of Contents

Advertisement

Available languages

Available languages

Frequently,
aproblem i sminor
and a service callmay not be necessary, use lhls troubleshootingguide for a
possiblesolution, II the unit continues to operate improperly, call Danby'sTo|! Free Number t-800-263-2629 for
assistance, or carlone of our service depots listed tn the enclosed ".Authorized Service Depot"listing provided
with this uniL
Difficulty
Air conditioner will
not operate.
Possible
Cause
No power touniL
inefficient or no cooling°
Dirty air filter.
Unit size inappropriate
for application,
Blocked alr flow
Power Interruption, settings
changed too quickly, or
compressor overload tdpped.
No]sy unit.
Loose parts
Inadequate supporL
...........................
i,,
,
,,,,, ....
Odors.
Formation of mold, mildew, or
algae on wet surfaces.
Water dripping outside.
Condensation run.off is normal
during hot and humid weather_
Water dripping inside.
Unit Is not properly angled to
allow water to drain outstdeo
Ice or frost build-up,
Low outside temperature.
Unlt alr filler is dlrty_
Suggested
Solution
Check connection of power cord to
power source.,
Check fuse or circuit breaker
Check the appropriate setting is selected
Clean or replace air filter,
Check with dealer to determine proper untt
capacity for application.
Remove obstruction from grill or
outdoor louvers.
Turn the unit off and wait 5 minutes before
attempting to restart
Tighten loose parts°
Provide additional support to unit,
Clean unit thoroughly.
Place algaectae tablet in base pan,.
Add flexible tubing to redirect water flow,
see Fig,25
Unit must be installed on an angle for proper
condensation run-off,. Check the unit and
make any adjustments.
When outdoor temperature is approximately
65°F or below, frost may form when unit is in
eooltng mode. Switch unit to FAN (only)
operation until frost melts.
Remove and ciean filter
NOTES;
1. ff circuit breaker is lripped repealed/y, or fuse is blown more than once, contact a
qualified technician.
2
When unit is installed using proper installation steps, uni_is properly tipped towards the outdoors
to allow for condensation run-off-
13

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents