1. Preparation to Remove the Air Conditioner
Slide-Out Chassis (All Models)
*
Posftion the air conditioner in the normar
(upright) position°
•
Remove the air filter by grasping the lJltarhandle
(on front gd]t) and s_[ding It to the rlghL Fig 2
*
Remove the phillips screw (behlnd filter)
seoudng the grill front to the chassis. (Fig. 4)
,
Remove the phillips screws located on 1he(lower
left.fright) edge of front grill (Fig.3)
•
To remove the front grill, grasp the lower front
corner of the grill, puiting (gen!ly) outward and
upward. (Fig.5)
Repeat this step on the 3 remain|rig comers..
,
Before the front grill can be completely removed
from the cabJnel, it wilt be necassary to
disconnect the (maleliemale) eleclrlcal wire
harness located directly behind the front gr_l..
{Fig 5a)
•
_emov_ the two phfllfps screws (lower left/right
side of cabinet) securing the slide-ouFchassb
Io
the cabinet. Fig.7
NOTE: These screws must be reinstalled
upon completion of the window installation.
(to secure slide-out-chassls)
NOTE: Some models may be inclusive of an
additional (slide-out chassis) retaining bracket and
screw located at the front of the chassis. This
bracket and screw must also be removed before
attempting to remove the sF_e-out chassis Fig_ 6
NOTE:This
bracket and screw does not have to
be reinstalled upon compbtlon of the window
installation.
Grasp the pull handle at the front of the slide-out-
chassis and carefully slide the air conditioner out
of the cabinet. (Fig.6)
Please seek assistance for this procedure.
Fig.1
Ftg.2
FRONT
PANEL
;
/
Fig. 3
Fiff_ 4
FIg, 5a
Flg_s
Fig. 6
.
tg_
out
._ltJw
Fig 7