Additional Features - Craftsman 335.25187 Owner's Manual

21. Remove stencil just routed and locate
next stencil in place. (Leave bit
cutter in groove.}
22. Loosen work piece and move work
piece to felt until stylus is on
STARTING POINT. Reclamp work
piece. Switch router on and proceed.
(Repeat until sign is completed.)
OTHER FOUR STYLES
23.
24.
To rout a sign using "Old English",
"Script", or "Far East" follow same
method as capital letters of "Modern
Writing", (Step 16-17-18) for set up
and spacing between letters. Use a
flat bottom router bit (1/8" diameter
works good). No need to rout deep.
Turn router on and guide stylus
around letter keeping stylus on inside
edge of letter. After bordering the
letter, remove SHADED AREA of
letter with a series of short strokes
being careful not to touch the edges
of the engraved border. (Guide the
unit using handle knobs while
watching the cutter, when routing
center shaded area way.) Turn router
off. Pick up handle bar and place
stylus on SPACING DOT at right of
stencil sheet, allowing cutter to rest
on 'wood. (This properly spaces
letters.)
Remove stencil of letter just routed
and place next stencil in place.
Loosen work piece and move to left
carrying router until stylus is on
LOCATING DOT. Rectamp work
piece.
ADDITIONAL
FEATURES
The pantograph has three settings which
gives different ratios of reduction from
stencil to engraving. Ratio is adjusted by
removing ADAPTER PIVOT CAPS on
both sides of adapter plate and adjusting
GUIDE ARM TUBE and LEFT SUPPORT
TUBE to the proper locating hole. Locate
router on adapter plate so router cutter is
IN LINE with stylus and PIVOT CORNER.
__SHADED AREA
SPACING DOT
LOCATING DOT
LEFT SUPPORT TUBE GUIDE ARM TUBE
ADAPTER PIVOTCAPS
RIGHT ,'_.
For 40% reduction,
assemble adaptor pivot
caps in front holes in
tubes with router to right
of adapter plate,
For 50% reduction,
assemble adapter pivot
caps in center holes in
tubes with router on
center of adapter plate.
For 60% reduction,
assemble adapter pivot
caps in rear holes in
tubes with router to left
side of adapter plate.
-8-