Craftsman 315.108240 Owner's Manual page 11

TO POCKET CUT
See Figure 18,
OPERATION
Adjust the bevel setting to zero and swing the lower blade
guard up using the lower btade guard handfe ALWAYS
RAISE THE LOWER BLADE GUARD WITH THE HANDLE
TO AVOID SERIOUS INJURY, WhiIe holding lower btade
guard by the handle, firmly rest the front of the base fiat
against the workpiece wit h the rear o! the handle raised so the
blade does not touch the work, See Figure 18 Push the lock-
off button down and squeeze the switch trigger
ALWAYS LET THE BLADE REACH FULL SPEED THEN
SLOWLY LOWER BLADE INTO THE WORK UNTIL BASE
IS FLAT AGAINST WORK_ After you comptete your cut
release the triggerand ailow the blade to come to a complete
stop. After the blade has stopped, remove it from the work
Corners may then be cleared out with a hand saw or sabre
SaW,
E
LOWER BLADE _ _
GUARD
POCKET CUT LOWER BLADE
GUARD HANDLE
Fig.18
THE FOLLOWING RECOMMENDED ACCESSORIES ARE CLIRRENT AND WERE AVAtLABLE AT THE TIME THIS -
MANUAL WAS PRINTED,
Carrying Case (9-14705)
Rip Guide (9-27679)
50' 14 A W G Ext Cord (9-5821)
100' 14 AWG, ExL Cord (9-83508)
71/4" Saw Bfade (9-32174)
7!/4" Saw Blade (9-32162)
71/4" Saw Blade (9-32122)
71/4" Saw Blade (9-32141)
71/4" Saw Blade (9-32134)
71/4" Saw Blade (9-32149)
71t4" Saw Blade (9-32526)
71t4" Saw Blade (9-32518)
71t4" Saw Blade (9_32489)
"l'heuse of attachments or accessortes not listed above might be hazardous,
Page 11