Advertisement
Figure 1
3. Remove the screws which locking the control panel (See figure1). Remove the power
button and unscrew the screws which locking the
panel. (See Figure 2 and 3.)
4. Take down the damaged circuit board and install a new
procedures to complete repairs. (See figure 3and 4.)
Figure 3
DOOR LATCH AND SWITCH ASSEMBLY
The latch and switch are located in the door assembly behind the control panel. The
dishwasher will not operate until the door is closed; the latch engages the door catch.
To Test Or Replace Door Switch.
1. Disconnect dishwasher from electrical supply.
2. Remove screws securing the control panel to the inner door (See Figure 1).
3. Remove wire leads from latch switch.
4. Use ohmmeter and check switch for continuity.
5. If the switch tests is good.
Check dishwasher electrical power.
Check to see if timer is defective.
If switch is defective remove door switch from latch assembly.
6. Install new switch and reverse procedures to complete repairs.
POWER BUTTON
circuit board
7
Figure 2
behind the control
circuit board
, reverse
Figure 4
Advertisement
