1. Manuals
  2. Brands
  3. Equator Manuals
  4. Dishwasher
  5. SF 924
  6. Installation instructions manual

Equator SF 924 Installation Instructions Manual

Fully integrated dishwasher
Hide thumbs Also See for SF 924:
Table of Contents

Advertisement

Quick Links

Download this manual See also: Owner's Manual
Installation Instructions
BEFORE YOU BEGIN
Read these instructions completely and
carefully .
IMPOR T ANT
governing codes and ordinances.
• Note to Installer – Be sure to leave these instructions
for the consumer s and local inspector '
Note to Consumer Keep these instructions with your
Owner`s Manual for future reference.
Installation of this dishwasher requires
Skill level
basic mechanical and electrical skills. Proper
installation is the responsibility of the installer .
Product failure due to improper installation is not
covered under the Our Dishwasher Warranty .
• Completion Time – 1 to 3 Hours. New installations
require more time than replacement installations.
READ CAREFULLY.
KEEP THESE
–
Observe all
Inspector s use.
INSTRUCTIONS.
Fully Integrated Dishwasher
Model SF 924
IMPORT ANT
MUST be installed to allow for future removal from
the enclosure if service is required.
If you received a damaged dishwasher , you should
immediately contact your dealer or builder .
FOR YOUR SAFETY
Read and observe all CAUTIONS and WARNINGS
shown throughout these instructions. While performing
installations described in this booklet, gloves, safety
glasses or goggles should be worn.
W ARNING
To reduce the risk of electrical shock, fire,
or injury to persons, the installer must
ensure that the dishwasher is completely
enclosed at the time of installation.
–
The dishwasher

Advertisement

Table of Contents
loading

Related Manuals for Equator SF 924

Summary of Contents for Equator SF 924

  • Page 1 Model SF 924 IMPORT ANT MUST be installed to allow for future removal from the enclosure if service is required. If you received a damaged dishwasher , you should immediately contact your dealer or builder . Observe all FOR YOUR SAFETY Read and observe all CAUTIONS and WARNINGS shown throughout these instructions.

  • Page 2: Parts Supplied

    PA RTS SUPPLIED: Two #8 Phillips flat head wood screws, 5/8" long to secure dishwasher to underside of countertop (in literature package). MA TERIALS YOU WILL NEED : Ferrule, compression nut and 90 ° Elbow (3/8"NPT external thread on one end, opposite end sized to fit water supply)

  • Page 3: Prepare Dishw Asher Enclosure

    . Installation Preparation ENCLOSURE • The dishwasher must be installed so that drain hose is no more than 10 feet in length for proper drainage. • The dishwasher must be fully enclosed on the top, sides and back, and must not support any part of the enclosure.

  • Page 4: Prepare Electrical Wiring

    NOTE: Power cords with plug must pass through a separate hole. Electrical Connection to Dishwasher Electrical connection is on the right front of dishwasher . • For cable direct connections the cable must be routed as shown in Figure 5. Cable must extend a minimum of 24"...

  • Page 5: Prepare Hot W Ater Line

    (Optional, but strongly recom- mended and may be required by local codes.) • Water connection is on the left side of the dishwasher . Install the hot water inlet line, using no less than 3/8"...

  • Page 6: Aesthetic Panel's Dimensions And Installation

    Install the hook on the aesthetic wooden panel and put the hook into the slot of the outer door of dishwasher(see Figure 7). After positioning of the panel , fix the panel onto the outer door by screws and bolts (see Figure 8).Take away the cover,then pin up the screw and get back the cover.
  • Page 7 Installation Instructions The aesthetic panel should be processed in accordance with the illustrated dimensions(unit:inch). 1.575 18 HOLES 1.52 2.047 23.386 22.362 21.26 Figure 10 9.843 0.591 0.177 0.06...

  • Page 8: Step 2 Adjust Leveling Legs

    Screws Figure 12 STEP 4 INST ALL LEGS Skip this step if dishwasher will be direct wired. The power cord and connections must comply with the National Electrical Code, Section 422 and/or local codes and ordinances. Recommended power cord length is 54 64"...

  • Page 9: Step 6 Positionw Ater Line And House Wiring

    Figure 15 STEP 7 INSERT DRAIN HOSE THROUGH CABINET • Upright the dishwasher and position in front of the opening. Insert drain hose into cabinet wall hole. If a power cord is used, guide the end through a separate hole.

  • Page 10: Step 10 Level Dishw Asher

    To Side dishwasher . If the rack rolls in either direction, the dishwasher must be leveled again. • If door hits the tub, the dishwasher is not installed correctly . Adjust leveling legs to align door to tub. Reposition Dishwasher...

  • Page 11: Step 12 Connect W Ater Supply

    STEP 11 SECURE DISHW ASHER TO CABINET The dishwasher must be secured to the countertop. • Position the dishwasher so that the tub flange aligns with the front face of the cabinet frame. IMPORTANT: Check to be sure the dishwasher is...

  • Page 12: Step 13 Connect Drain Line

    WASHER WILL NOT DRAIN IF PLUG IS LEFT IN PLACE. TIP: Avoid unnecessary service call char ges. Always be sure disposer drain plug has been removed before attaching dishwasher drain hose to the disposer . waste tee or disposer with...

  • Page 13: Step 14 Connect Power

    Verify that power is turned off at the source. • Remove junction box Cover A . “ A ” . • Locate the three dishwasher wires, (white, black and green) with stripped ends. Insert dishwasher wires through the small hole in the junction Box B .

  • Page 14: Step 17 Replace Toekick

    Reposition the dishwasher if necessary.See step 9. The dishwasher will drain and turn off about 5 to 7 minutes after the first fill.Check dain lines.If leaks are found,turn power off at the breaker and correct plumbing as necessary.Restore power ater corrections are made.See Step 12.
  • Page 15 EQUATOR CONTACT NUMBERS SERVICE: (800) 776-3538 PARTS & SUPPORT: (888) 483-9627 Equator Corporation Equator Plaza 2801 W. Sam Houston Parkway N. Houston, Texas 77043-1611 Tel: 713-464-3422 Fax: 713-464-2151 Toll Free: 800-935-1955 All Rights Reserved Manual subject to change without notice...

Table of Contents