Advertisement
The troubleshooting cheek list is common for all dishwasher models. They use
different parts to accomplish the same thing and diagnosis will remain similar.
When a problem arises, and a possible cause is listed, follow the test, remove or
replace procedures as outline in this service manual. The wiring diagram,
shematic and timer cycle chat is a necessity when making electrical checks. In
most cases an ohmmeter will handle all the tests necessary.
For checking any particular cycle of operation, it absolutely necessary that the
cycle be set up as outlined in the product owner's guide.
SYMPTOM
Dishwasher
will
operation when turn on
Dishwasher stop
washing
but draining
Water can't pour out from
float support when pull out
the rubber cap.
Dishwasher runs but not
heat
Dishwasher will not stop.
Dishwasher runs with door
open
Motor hums but will not
TROUBLESHOOTING
CHECK THE
FOLLOWING
●fuse (blow nor tripped)
not
● Supply line receptacle, wiring
harness.
● Circuit board (contacts open or
burnt).
●
Motor
(inoperative,
resistances).
●Door switch (open contacts)
●Door latch not making contact with
door switch.
● Overflow occur.
●Hole in the float supply is jammed.
●heater element (open).
●Timer contacts (open or burnt).
● Wiring or terminal (burnt or
broken).
● Thermostat is closed.
●Timer motor (inoperative).
● Wiring or terminal (burnt or
broken).
●Timer (open or burnt contact).
●Defective door safety switch.
●Start winding(open).
◇Replace fuse or reset breaker.
◇Repair or replace.
◇Replace circuit board.
◇Replace motor.
check
◇Replace door switch.
◇ Replace or adjust to make
contact.
◇ Check the reason of overflow
pull out the rubber cap wait for a
minute let water pour out.
◇Suck with dust cleaner or other
let water pour out.
◇Replace heater element.
◇Replace timer.
◇Repair or replace.
◇Replace.
◇Replace timer.
◇Repair or replace.
◇Replace timer.
◇Replace door safety switch.
◇Replace motor.
10
REMENDY
Advertisement
