Table of Contents
Advertisement
D ADJ
;TNI NTS
CAUTION:
BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:
•
Release control bar.
,
Make sure the blade and all moving parts have completely stopped.
°
Disconnect spark plug wire from spark plug and place where it cannot come in contact with plug.
LAWN MOWER
TO ADJUST CUTTING
HEIGHT
See "TO ADJUST CUTTING HEIGHT" in the Operation
section of this manual
REAR
DEFLECTOR
The rear deflector, attached between the rear wheels of
your lawn mower, is provided to minimize the possibility
that objects will be thrown out the rear of the lawn mower
into the operator's mowing position.
If the rear deflector
becomes damaged, it should be replaced.
TO REMOVE/REPLACE
DRIVE BELT
(See Fig. 16)
•
Remove drive cover_ Remove belt by pushing down
on gear case pulley,,
-
Turn lawn mower on its side with carburetor and fuel
cap up,_
.
Remove blade_
.
Remove debris shietd,_
.
Remove belt from engine pulley on crankshaft,
.
Install new belt by reversing above steps.
°
Always use factory' approved belt to assure fit and
long life.
DRIVE
COVER
BELT
PRESS
FIG. 16
15
Advertisement
Table of Contents
