TO REPLACE
MOWER
BLADE
DRIVE BELT
The mower blade drive belt may be
replaced without tools, Park the tractor
on level surface. Engage parking brake°
BELT REMOVAL -
• Remove mower from tractor (See "TO
REMOVE MOWER" in this section of
this manual),
° Work belt off both mandrel pulleys and
idler pulleys,
• Pull belt away from mower.
BELT INSTALLATION
-
° Install new belt in reverse order of
removal.
° Make sure belt is In all pulley grooves
and inside all belt guides,
° Install mower tn reverse order of
removal instructions.
Mandrel
Idler
Pulley
TO ADJUST
BRAKE
Your tractor
Is equipped
with an adjust-
able brake system
which Is mounted
on
the right side of the transaxle,
If tractor
requires
more than sl× (6) feet
stopplng
distance
at hlgll speed
in
higllest
gear, then brake must be
adjusted.
• Depress
clutch/brake
pedal
and
engage
parking
brake.
° Measure
distance
between
brake
operating
arm and nut "A" on brake
rod.
• If distance
is other than 1-t/2",
loosen
jam nut and turn nut "A" until distance
becomes
I-1/2",
Rettghten
Jam nut
against nut "A".
° Road test tractor for proper stopping
distance as stated above, Readjust if
necessary.
If stopping distance is still
greater than six (6) feet in highest
gear, further maintenance is neces-
sary. Contact your nearest
authorized
service center/department.
With Parking
Brake "Engaged"
"''_Jl
Nut "A"
Jam Nut
,_q
.,--'1-_ Operating
Aim
TO REPLACE
MOTION
DRIVE BELT
Park the tractor on level surface,
Engage
_arklng brake, For assistance, there is a
elt Installation guide decal on bottom
side of left footrest,
= Remove mower (See "TO REMOVE
MOWER" In this section of this
manuaL)
o Remove belt from stationary idler and
clutching Idler.
= Pull belt slack toward rear of tractor.
Remove belt upwards from transaxle
pulley by deflecting belt keepers,
• Pull belt toward front of tractor and
remove downwards from around
engine pulley,
- Install new belt by reversing above
procedure:
Engine
Otutchln
Transaxle
22