To Replace Mower Drive Belt; Mower Drive Belt Removal; Mover Drive Belt Installation - Craftsman 917.276020 Owner's Manual

TO REPLACE _,_OWER DRmVE BELT
MOWER DRIVE BELT REMOVAL
1. Park tractor on a level surface. Engage
parking brake.
2. Lower mower to its lowest position.
3. Remove screws from R.H. mandrel
cover and remove cover.
4. Remove any dirt or grass clippings
which may have accumulated around
mandrels and entire upper deck sur-
face.
5. Disconnect R.H. suspension arm from
rear deck bracket by removing retainer
spring.
6. Carefully roll belt over the top of R.H.
mandrel pulley.
7. Remove belt from electric clutch pulley.
8. Remove belt from idler pulleys.
9. Check primary idler arm and two idlers
to see that they rotate freely.
10.Be sure spring is securely hooked to
primary idler arm and spring arm.
MOWER DRIVE BELT INSTALLATION
11. Install belt in both idlers.
12. Install new belt onto electric clutch pul-
ley.
13. Carefully roll belt into upper groove of
R.H. mandrel pulley.
14. Carefully check belt routing making
sure belt is in the grooves correctly.
15. Reconnect R.H. suspension arm to
rear deck bracket with retainer spring.
16. Reassemble R.H. mandrel cover.
R.H. Mandrel
Cover
I
Electric
Clutch
Pulley
Idler
Pulleys
S
Arm
m.m_
Mandrel
m.m.
Suspension Primary
Arm Idler Arm
23