GE Profile WPRB9220 Owner's Manual page 16

Before you call for service...
WATER(cont.) Possible Causes What ToDo
Water pumped out Lid lifted or cycle was put in • Reset cycle.
before cycle is complete pause for over 24 hours
Water won't drain Drain hose is kinked or • Straighten drain hose and make sure washer is not
improperly com_ected _sittino_on it.
• Top of drain outlet should be less than 8 tt (2.5 m)
above flooi:
Water spraying during
Washer in spin cycle • Spra} rinse dining a spin cycle is n(mnal.
spin cycle
Washer did not fill ]_tremely low water pressure = Press the START pad again.
to chosen level
Inlet hoses are kinked = Straighten hoses.
Water valve scree_)s are • Tm'n off the water source and disconnect w;_ter fill
stopped up hoses ti'om the ui)per back of the washe_: Use a brush
or toOthlfick to clean the screens in the machine.
Reconnect the hoses and ttu'n the w;_ter back on.
Water fills and drains Drain stand pipe is too low • Drain stand pipe must be above 30" (76.2 cm).
at the same time
NOISE Possible Causes What ToDo
Washer is noisy Washer is uneven • To level the ti'ont ot the washer, a(!iust the ti'ont leveling
legs by rotating the individual leg in the proper direction
fin" up or down. To level back of washe_; lift back _ff
machine 4" (11 cm) and set down.
Washer load is mthalm_ced
• Press STARTto pause
the washe_; open the lid and
redistribute the load evenly. Close the lid and press
START'again.
Shipping rod is still assembled " To remove shiplfing rod ti'om washe_; ptfll yellow tag and
in unit attached rod fl'om the bottom right hand side ot washer.
Washer is sitting too close • Ptfll washer away ti'om the wall; about 4" (11 cm)
to wall (causes knocking is needed.
during cycle)
PeffecTemp Plus feature " This is nomml. PeffecTemp Plus turns water valves off
is being used and on to a(!iust water temperatm'e.
OTHER Possible Causes What To Do
Labels on the exterior
of the washer will not
peel off cleanly
Occasionally the adhesive
used on the labels does
not release clemfly
" Use a hair (hyer set at the lowest heat setting, directing
the air at the label fi)r a short amount of time. This will
release the adhesive easily, without damaging the sm_hce
of the washex:
/6