GE Profile WPRB9220 Owner's Manual page 15

www.GEAppliances.com
OPERATION (cont) Possible Causes What ToDo
Washerwon'toperate
START was not pressed • Press
START
Extremely low water pressure = Press
STARTagain.
Washer was accidentally paused = If the light on the
DELAY
STARTpad
is flashing, the
when starting Delay Start washer is paused. Press
STARTto
restmX the countdown.
WATER Possible Causes What ToDo
Toomanysuds
Type of detergeut • Switch to a lower stldsiug detergeut l)i';lil(l ;111(1fbllow
instructions on package.
Very soft water • T_ less deteroent
Too much detergent • Measm'e pmr dem_gent careflflly, Use less soap if you
have soft water; a smaller load or a lightly soiled load.
Waterleaks Fdl hoses or da'aJn hose is • Make sure hose com_ections are tight at fimcets
improperly com_ected and at washe_:
• Make sure eud of draiu hose is properly couuected
to washer and correctly inserted in and secured to
drain facility.
Household dxaJn may • Check household i)lmnbing. You may need to call
be clogged a i)lmnbe_;
Consm_lt water pressure to the • Tighten hoses at the fimcets and tm'n the water off
fill hoses at the water source after each use.
• Check condition of the fill hoses; they should be
replaced eve_ T 5 vem_.
Using too much detergent • Use less detergent. Use less soap if you haxe soft water;
in washer a smaller load or a lightly soiled load.
Water temperature
Cooler water temperatures • New latm(h T detergents have been titan ulated to work
seems incorrect provide hnpmved energy with cooler water temi)eratures .... without aflecfiug, wash
efficiency perfinm a rice.
Control is not set properly • Check water telnl)erature control and a(!just.
Water supply is turned off • Tm'n both hot and cold fimcets hilly on and make sm'e
or improperly cmmected hoses are comaected to correct fimcets,
Water valve screens axe • Tm'n off the water source and disc(mnect water
fill
stopped up hoses fl'om the upper back of the washe_; Use a brush
or toothpick to clean the screens in the machine.
Recmmect the hoses and mrn the water back on.
House water heater is • Make sure house water heater is delivering water
not set properly at 120°g-140°F (48°C-60°C).
PetfecTemp Plus feature
• The
lid must be closed for
Peffecremp Plus to work.
was not activated
Wash temperature was set to
• _._]_en the
Tap Cold featm'e is selected, the water
TAP COLD temperature may vm T depending on the temperature of
your household tap _lte_:
/5