Error Messages - Sharp MD-MT80W Operation Manual

Error Messages

ERROR MESSAGES
z The battery is run down.
BATT EMPTY
z Nothing is recorded.
BLANK MD
z You tried to record from a copy prohibited
Can't COPY
MiniDisc.
z A track cannot be edited.
Can't EDIT
z The disc data cannot be read because the
Can't READ (*)
disc or unit is damaged.
z Recording cannot be performed correctly
Can't REC
due to vibration or shock.
z Stamp function does not work.
Can't STAMP
z Cannot save the TOC information correctly
Can't WRITE
to a MiniDisc. (A large portion of the disc has
been damaged.)
z The disc is scratched.
DEFECT
z The disc is out of recording space.
DISC FULL
z The microprocessor has reported a system
Er-MD (**)
fault and the unit is out of order.
z The unit is in the hold mode.
HOLD
z You removed a MiniDisc whilst recording or
LOCKED
editing.
z A disc has not been loaded.
NO DISC
Number or symbol appears in (*) position.
42
MEANING
z Charge the rechargeable battery or replace the al-
kaline battery (or use the AC adaptor for power).
z Replace the disc with a recorded disc.
z Record using the analogue cable.
z Change the stop position of the track and then edit it.
z Reload the disc.
z Replace it with another recorded disc.
z Re-record or replace it with another recordable
disc.
z Check the number of tracks.
z Replace the disc with another recordable disc.
z If the sound you hear is not right, record again.
z Replace the disc with another recordable disc.
z Replace it with another recordable disc.
z To have it repaired, go to the distributor where you
purchased the unit.
z Cancel the hold mode.
z Turn off the power and remove the MiniDisc.
z Load a disc.
00/12/26
REMEDY
80SCA_40_47.FM