Sharp HT-SB400 Operation Manual page 16

General control (continued)
HT-SB400
■ Subwoofer level control
The subwoofer level can be adjusted.
To increase the level, press the
SUBWOOFER LEVEL
To decrease the level, press the
SUBWOOFER LEVEL
Note:
When sound from the speaker is distorted, decrease the
subwoofer level.
■ Centre speaker level control
The centre speaker level can be adjusted.
To increase the level, press the
CENTER SPK LEVEL
To decrease the level, press the
CENTER SPK LEVEL
■ Bass control
1. Press the BASS/TREBLE button
to select "BASS".
2. Within 5 seconds, press the
VOLUME (+ or –) button to adjust
the bass.
■ Treble control
1. Press the BASS/TREBLE button
to select "TREBLE".
2. Within 5 seconds, press the
VOLUME (+ or –) button to adjust
the treble.
16
button.
button.
-5 -4 ...
button.
button.
-5 -4 ...
■ Touch Sensing Off mode
During Stand-by mode, press the DIMMER/SENS ON/OFF
button on the remote control and the On/Stand-by indicator will
turn from orange to red.
To turn the power on, press the ON/STAND-BY button on the
+4 +5
remote control or touch the ON/STAND-BY pad on the display
panel.
■ Function
When the FUNCTION
speaker is touched or LINE 1 - 2
button on the remote control is
pressed, the
change. Touch the FUNCTION pad
+4 +5
on speaker or LINE button on the
remote control repeatedly to select
desired input source.
Note:
The backup function will protect the memorised function mode
for a few hours should there be a power failure or the AC power
lead becomes disconnected.
-5 +5
Auto power on function:
When you press the LINE button on the remote control, the
speaker will turn on at last function.
Auto power off and auto detect signal:
The speaker will automatically power off after 1 minute of
-5 +5
inactivity. The On/Stand-by indicator turns orange. At this point,
it will automatically power ON if it detects audio signal from
connected equipment.
Note:
Make sure to turn off any source/signal input to speaker before
going to stand-by mode because it will cause the speaker to
power ON again.
pad on
LINE 1
input source will
LINE 2