Using External Units - Sharp GX-CD1200WBK Operation Manual

USING EXTERNAL UNITS

FUNCTION
MIX MIC
RECORD PLAY
Mixing from a microphone and TAPE
To listen to or record mixed signals from an external mi-
crophone and TAPE.
1
To protect the speakers from shock noise and to avoid dis-
turbing noises, set the VOLUME control to minimum.
Be sure that the microphone has a 3.5 mm (1/8") diameter
plug, and is of 600 ohms impedance; if not, use an appro-
priate adaptor.
2
Connect the microphone plug to the MIX MIC socket.
3
Set the FUNCTION switch to TAPE.
4
Load a cassette into the TAPE 1 or TAPE 2 cassette com-
partment.
5
Press the PLAY button of the TAPE 1 or TAPE 2.
6
Adjust the volume of the audio source and the microphone
using the VOLUME control.
For mixing recording
1
Perform steps 1 - 3 above.
2
Load a blank tape into the TAPE 1 cassette compartment.
Insert a prerecorded cassette into the TAPE 2 cassette
compartment.
3
Set the DUBBING SPEED switch to NORMAL.
Mixing recording is not possible if the DUBBING SPEED
switch is set to HIGH.
4
Press the RECORD button of TAPE 1.
5
Press the PLAY button of TAPE 2.
Notes:
Place the microphone about 10-15 cm (4-6") away from
the source.
If howling occurs, lower the volume or move the microphone
as far as possible from the speakers.
To record the microphone signals only, load a cassette into
the TAPE 1 cassette compartment, set the FUNCTION
switch to TAPE and the DUBBING SPEED switch to NOR-
MAL. Then, press the RECORD button.
Caution:
When not using the microphone, remove the microphone
plug from the MIX MIC socket.
PLAY/PAUSE
To listen to or record mixed signals from an external mi-
DUBBING
crophone and CD.
VOLUME SPEED
1
2
3
4
5
6
PLAY
For mixing recording
1
2
3
4
5
E-11
Mixing from a microphone and a CD
To protect the speakers from shock noise and to avoid dis-
turbing noises, set the VOLUME control to minimum.
Be sure that the microphone has a 3.5 mm (1/8") diameter
plug, and is of 600 ohms impedance; if not, use an appro-
priate adaptor.
Connect the microphone plug to the MIX MIC socket.
Set the FUNCTION switch to CD.
Load a compact disc into the CD compartment.
Press the PLAY/PAUSE button on the CD.
Adjust the volume of the audio source and the microphone
using the VOLUME control.
Perform steps 1 - 4 above.
Load a blank tape into the TAPE 1 cassette compartment.
Set the DUBBING SPEED switch to NORMAL.
Mixing recording is not possible if the DUBBING SPEED
switch is set to HIGH.
Press the RECORD button of TAPE 1.
Press the PLAY/PAUSE button on the CD.
Headphones
Before plugging in or unplugging the headphones, make
sure the volume level is reduced.
Be sure your headphones have a 3.5 mm (1/8") diameter
plug and are between 16 ohms and 50 ohms impedance.
The recommended impedance is 32 ohms.
Connect the headphones plug to the PHONES socket. The
speakers will be automatically disconnected. Adjust the
volume by using the VOLUME control.
PHONES