Remote Control; Battery Installation - Sharp CD-XP120W Operation Manual

Remote control

CD-XP120W
ENGLISH

! Battery installation

1 Remove the battery cover.
2 Insert the batteries according to the direction indicated in
the battery compartment.
When inserting or removing the batteries, push them towards the
battery terminals.
3 Replace the cover.
Precautions for battery use:
" Replace all old batteries with new ones at the same time.
" Do not mix old and new batteries.
" Remove the batteries if the unit is not to be used for long periods
of time. This will prevent potential damage due to battery leak-
age.
Caution:
" Do not use rechargeable batteries (nickel-cadmium battery, etc.).
" Installing the batteries incorrectly may cause the unit to malfunc-
tion.
Notes concerning use:
" Replace the batteries if the operating distance is reduced or if the
operation becomes erratic. Purchase 2 "AA" size batteries (UM/
SUM-3, R6, HP-7 or similar).
" Periodically clean the transmitter on the remote control and the
sensor on the unit with a soft cloth.
" Exposing the sensor on the unit to strong light may interfere with
operation. Change the lighting or the direction of the unit.
" Keep the remote control away from moisture, heat, shock, and
vibrations.
E-11
! Test of the remote control
Check the remote control after checking all connections have been
made correctly. (See pages 7 - 9.)
Point the remote control directly at the remote sensor on the unit.
The remote control can be used within the range shown below:
Press the ON/STAND-BY button. Does the power turn on? Now,
you can enjoy music.
Remote sensor
02/5/27 CD-XP120W(A)2.fm
0.2 m - 6 m
(8" - 20')