Preparing The Remote Control; Inserting The Batteries; Remote Control Range - PLUS Vision U7-132 User Manual

Preparing the Remote Control

Inserting the Batteries

When using the remote control for the first time, install the batteries that were supplied.
Slide the battery compartment
1
cover (located on the bottom
of the remote control) and pull
off.
CAUTION
When replacing batteries, purchase two of the same type of AAA battery.
Heed the regulations in effect in your region on the disposal of spent batteries.

Remote Control Range

Point the infrared transmitter of the remote control toward the remote control sensor located at the front or rear of the main unit
and operate.
Reception of the remote control signal should generally be possible within the range illustrated below.
Top View
Remote control
sensor
1m /
3.3 feet
1.5m / 4.9 feet
Note
* Exposure of the main unit's remote control sensor or the remote control infrared transmitter to bright light or the obstruction of the signal
by an obstacle located in the pathway may prevent operation.
* The remote control will not function when the battery is exhausted.
Insert the batteries to match
2
the "+" and "–" as indicated in-
side the compartment.
Remote control
infrared transmitter
40°
40°
5m / 16.4 feet
(A) Leaving a little space in the front, close
3
the lid, (B) then with the back pressed tightly,
(C) press the lid towards the front.
Side View
20°
1.5m / 4.9 feet
Remote control
sensor
E-12
(A)
Remote control
infrared transmitter
5m /
16.4 feet
30°
20°
20°
5m / 16.4 feet
(B)
(C)