Return From Copy Mode Timing; Language Setting; Operation Setting; Auto Clear - Sharp AR-M161 Operation Manual

System requirements for USB 2.0
(Hi-Speed mode)
The USB port (USB-2) on the machine supports
USB 2.0 Hi-Speed mode.
The following system is required to use USB 2.0
(Hi-Speed mode):
The computer is running Windows XP/2000 and the
Microsoft USB 2.0 driver is pre-installed, or the
USB 2.0 driver for Windows XP/2000 that Microsoft
provides through Windows Update is installed.
* Even when the Microsoft USB 2.0 driver is installed,
some USB 2.0 expansion cards are not capable of
attaining the speed stipulated by the Hi-Speed
standard. This problem can often be fixed by installing
a more recent driver for the card. To obtain the most
recent driver for your card, contact the card's
manufacturer.

RETURN FROM COPY MODE TIMING

When there are print jobs or fax print jobs waiting to be
printed after copy job is finished, this program is used
to set a brief wait time until printing of those jobs
begins. Setting a brief wait time allows another copy
job to be performed following the previous copy job.
Time selections are "0 sec.", "10 sec.", "30 sec.", and
"60 sec.".
The factory default setting is 30 seconds.
Select "RETURN FROM COPY MODE TIMING" and
press the [OK] key. The following screen will appear.
RETURN FROM COPY
30 sec.
(0~60)
1
Select the desired time with the [ ] or [ ]
key.
2
Press the [OK] key.

OPERATION SETTING

These programs are used to configure various settings
related to the operation panel. To access one of these
programs, select "OPERATION SETTING" in the
mode selection screen, select the desired program in
the operation setting screen, and press the [OK] key.

AUTO CLEAR

This function returns the copy settings to the default
settings if the operation panel is not used for the
duration of time set with this program following the end
of a copy job. Time selections are "0 sec.", "10 sec.",
"20 sec.", "60 sec.", "90 sec." and "120 sec.".
The factory default setting is 60 seconds.
Select "AUTO CLEAR" and press the [OK] key. The
following screen will appear.
AUTO CLEAR
60 sec.
(0~120)
1
Select the desired time with the [ ] or [ ]
key.
If you do not want auto clear to operate, select "0".
2
Press the [OK] key.

DISABLE DISPLAY TIMEOUT

This program is used to select whether or not the
display will automatically return to the base screen if
no keys are pressed on the operation panel for one
minute in scan or fax mode.
The factory default setting is automatic return to the
base screen.
To disable automatic return to the base screen, select
"DISABLE DISPLAY TIMEOUT", and press the [OK]
key so that a checkmark appears in the checkbox.
To re-enable automatic return to the base screen,
select "DISABLE DISPLAY TIMEOUT" once again
and press the [OK] key to clear the checkmark
from the checkbox.

LANGUAGE SETTING

This program is used to select the display language.
Select "LANGUAGE SETTING", press the [OK] key,
and follow the steps below.
1
Select the display language with the [ ] or
[ ] key.
2
Press the [OK] key.

MESSAGE TIME

This program is used to set the length of time that
messages appear in the display (this applies to
messages that appear for a certain length of time and
then automatically disappear.) Select from "SHORT (3
sec.)", "NORMAL (6 sec.)", or "LONG (9 sec.)".
The factory default setting is "NORMAL (6 sec.)".
KEY OPERATOR'S GUIDE
83
7