Switching The Display - Sharp FU-800-J Operation Manual

SWITCHING THE DISPLAY

Regardless of the operational status, the current time and three pairs of pre-
set timer set-up times are displayed on the Digital Display area by pressing
the time button.
The Digital Display is switched as follows every time the CLOCK
Button is pressed.
Current Time
ON Time 1
OFF Time 1
ON Time 2
OFF Time 2
ON Time 3
OFF Time 3
How to cancel the times set for the Preset Timer.
1
Press the CLOCK Button, and display the ON Time
to be cancelled.
• The ON Timer Lamp is turned on.
2
Press the SET Button.
• The ON Timer Lamp blinks.
3
Press the CLOCK Button
• The Digital Display area shows a bar.
4
Press the SET Button
• Cancellation is validated.
When an On time is cancelled, its corresponding Off time is auto-
matically cancelled as well.
"beep"
"beep"
"beep,beep"
"beep,beep"
"beep,beep,beep"
"beep,beep,beep"
"beep"
E-19
NOTES
• If the time has not been set, bars
are displayed.
• When an on or off time is left dis-
played for about eight seconds, the
display reverts to the current time.
• While the unit is stopped, if the
SET Button is pressed when an on
or off time is displayed, the adjust-
ment mode for the displayed time
is activated.
• While the unit is stopped, if the
SET Button is pressed when the
current time is displayed, the ad-
justment mode for the current time
is activated.