When Connecting Using Telnet - Sharp PG-D45X3D Setup Manual

When Connecting Using
Telnet
1 1
Click "Start" from the Windows
desktop and select "Run".
2 2
Enter "telnet 192.168.150.2" in the
text box that opens up. (If the IP
address of the projector is
192.168.150.2.)
3 3
Click the "OK" button.
4 4
"User Name:" is displayed. Input
the user name and press the
"Enter" key.
• If a user name has not yet been set, just
press the "Enter" key.
5 5
"Password:" is displayed. Input
the password and press the
"Enter" key.
• If a password has not yet been set, just press
the "Enter" key.
6 6
Input "setup" and press the
"Enter" key.
• SETUP MENU will be displayed.
Setting up the Projector Using RS-232C or Telnet
▼SETUP MENU
-----------------------------SETUP MENU----------------------------
[1]IP Address
[4]User Name
[6]RS-232C Baud Rate [7]Projector Name [8]DHCP Client
[A]Advanced Setup
[V]View All Setting
®
setup>
• If the IP address has been changed, be sure to
enter the new IP address in step 2.
• User name and password are not set in the
factory default settings.
• If the user name or password is entered
incorrectly three times in steps 4 or 5, SETUP
MENU will be quit.
[2]Subnet Mask
[5]Password
[S]Save & Quit
Note
[3]Default Gateway
[D]Disconnect All
[Q]Quit Unchanged
-21