Dvd Setup; Audio Setting; Black Level Setting; Display Setting - Sharp DV-S11S(G Operation Manual

DVD SETUP

Audio Setting

Choose the appropriate Audio settings for your music equip-
ment.
NOTE:
• These audio settings are effective only when using a digi-
tal connection. Although you may change the settings
from the on-screen display, these audio settings do not
actually affect the sound when using an analogue con-
nection.
1
Press SETUP during playback is stopped.
2
Press K or L to select AUDIO, then press ENTER.
3
Press K or L to choose the below items and press
ENTER repeatedly to turn the setting ON or OFF.
Dynamic Range Control (DRC):
• The default setting is OFF.
• To compress the range of sound volume.
Dolby Digital :
• The default setting is Bitstream.
(Bitstream : Output by Dolby Digital)
(DPCM : Convert the Dolby Digital to D-PCM)
Set to Bitstream when the unit is connected to Dolby
Digital Decoder.
DTS:
• The default setting is OFF.
Set to On when the unit is connected to DTS Decoder.
(On: Output by DTS)
MPEG:
• The default setting is OFF.
(On : Output by MPEG sound)
(OFF: Convert the MPEG to PCM)
Set to On when the unit is connected to MPEG
Decoder.
DOWN SAMPLING:
• The default setting is AUTO.
• Press ENTER, then K or L to select AUTO, 48kHz or
96kHz. Press ENTER again to confirm selection.
• Select 96kHz if the disc was recorded in PCM 96kHz,
otherwise select 48kHz.
4
Press SETUP to exit.

Black Level Setting

Adjust the Black Level Settings to make the black parts of
the picture as bright as you prefer.
1
Press MODE during playback.
2
Press ENTER repeatedly to select ON or OFF.
ON: makes the dark parts brighter.
OFF: shows the original picture as recorded.
NOTE:
• Black Level Setting is not available if your TV is set to
receive the RGB signal (see page 8 for more information).

Display Setting

You can change certain aspects of the DVD's display
screens, on-screen messages and the display panel on the
front of the DVD player.
1
Press SETUP during playback is stopped.
2
Press K or L to select DISPLAY, then press
ENTER.
3
Press K or L to select the below items, then press
ENTER.

TV Aspect

Aspect ratio of the
received signal.
K or L
• Press
ENTER.
• Select 4:3 LETTER BOX for a
black bars appears on the top
and bottom of the screen.
• Select 4:3 PAN & SCAN for a
full height picture with both
sides trimmed.
• Select 16:9 WIDE if a wide-
screen TV is connected to the
DVD player.

Panel Display

K or L
• Press
then press ENTER.
• This adjust the brightness of the display panel with the
factory default BRIGHT.
• When AUTO is selected, the display dims only during
playback.

Angle Icon

• Press ENTER repeatedly to turn Angle icon ON or OFF.
• The default setting is ON.

Auto Power Off

Auto Power Off:
• Press ENTER repeatedly to turn Auto Power ON or
OFF.
• The default setting is ON and it will turn the DVD player
to off automatically after 35 minutes of no use.
4
Press SETUP to exit.
– 18 –
16
9
for an item selection, then press
3
3
9
to select BRIGHT, DIMMER and AUTO,
4
4
16
EN