DVD SETUP
Audio Setting
Choose the appropriate Audio settings for your equipment as
it only affect during the playback of DVD discs of the DVD
player.
NOTE:
•
These audio settings are effective only when using a digi-
tal connection. Although you may change the settings from
the on-screen display, these audio settings do not actually
affect the sound when using an analogue connection.
1
Press SETUP during playback is stopped.
2
Press K or L to select AUDIO, then press ENTER.
3
Press K or L to choose the below items and press
ENTER repeatedly to turn the setting ON or OFF.
Dynamic Range Control (DRC):
• The default setting is OFF.
• To compress the range of sound volume.
Dolby Digital :
• The default setting is BITSTREAM.
(BITSTREAM : Output by Dolby Digital)
(DPCM : Convert the Dolby Digital to D-PCM)
Set to BITSTREAM when the unit is connected to Dolby
Digital Decoder.
DTS:
• The default setting is OFF.
Set to ON when the unit is connected to DTS Decoder.
(ON: Output by DTS)
MPEG:
• The default setting is OFF.
(ON : Output by MPEG sound)
(OFF: Convert the MPEG to PCM)
Set to ON when the unit is connected to MPEG Decoder.
DOWN SAMPLING:
• The default setting is AUTO.
• Press ENTER, then K or L to select AUTO, 48kHz or
96kHz. Press ENTER again to confirm selection.
• Select 96kHz if the disc was recorded in PCM 96kHz,
otherwise select 48kHz.
4
Press SETUP to exit.
Black Level Setting
Adjust the Black Level Settings to make the black parts of
the picture as bright as you prefer.
1
Press MODE during playback.
2
Press ENTER repeatedly to select ON or OFF.
ON: makes the dark parts brighter.
OFF: shows the original picture as recorded.
Display Setting
You can change certain aspects of the DVD's display
screens, on-screen messages and the display panel on the
front of the DVD player.
1
Press SETUP during playback is stopped.
2
Press K or L to select DISPLAY, then press
ENTER.
3
Press K or L to select the below items, then press
ENTER.
TV Aspect:
K or L
• Press
ENTER.
• Select 4:3 LETTER BOX for a black bars appears on
the top and bottom of the screen.
• Select 4:3 PAN & SCAN for a full height picture with
both sides trimmed.
• Select 16:9 WIDE if a wide-screen TV is connected to
the DVD player.
• The default setting is 4:3 LETTER BOX.
Panel Display:
K or L
• Press
then press ENTER.
• This adjust the brightness of the display panel with the
factory default BRIGHT.
• When AUTO is selected, the display dims only during
playback.
Angle Icon:
• Press ENTER repeatedly to turn Angle icon ON or
OFF.
• The default setting is ON.
Auto Power Off:
• Press ENTER repeatedly to turn Auto Power ON or
OFF.
• The default setting is ON and it will turn the DVD player
to off automatically after 35 minutes of no use.
4
Press SETUP to exit.
– 18 –
for an item selection, then press
to select BRIGHT, DIMMER and AUTO,
EN