Watching Tv; Watching A Tv Programme - Sharp 20AG2-SMK3 Operation Manual

Watching TV

TV Set (Bottom)
POWER
Power indicator
CH
CH
TV/VIDEO
1
1 2 3
4 5 6
5
7 8 9
0
CH
CH
CH
CH
FEATURE TIMER PICTURE
CH-SET NORMAL
TV
• When the power indicator lights up dimly, either
on the power.
• The channel number is displayed in green for channels tuned by auto tuning and displayed in yellow for
channels tuned using fine tuning.
• When the power indicator lights up dimly, the TV is in Standby mode and power is still supplied to the
TV. If you will not watch TV for a while, turn off the main power by pressing
Also, if you will not be at home for a considerable length of time, unplug the cord from the outlet.
• The AV1 and AV2 input channels cannot be selected using
Use TV/VIDEO
• Channels that have been skipped cannot be selected by
• The on-screen displays in this manual may differ from their actual appearance.

Watching a TV programme

Simple operations for watching a TV programme
1
Turn on power.
• When the power indicator is off, press
• When the power indicator lights up dimly, press
remote control. The power indicator changes to bright and a picture
appears.
2
Select channel.
With
CH
• Press
CH
1 / 2 / ... / 98 / 99 / AV1 / AV2 / 0 / 1 / 2 ...
• Press
CH
1 / 0 / AV2 / AV1 / 99 / 98 / ... / 2 / 1 / 0 ...
With the number buttons (on remote control)
• To select a one-digit channel, such as 5, press
If "5-" is indicated, press
press
• To select a two-digit channel, such as 15, press
the two-digit input. Press
3
Adjust volume using
• The number of oval blocks " "
indicates the volume level.
The volume bar disappears
approximately three seconds after
the volume has been adjusted.
to select these channel.
/
CH
and channels change as shown below.
and channels change as shown below.
again.
5
1
.
CH / CH
CH
CH
.
POWER
on the
.
5
to select one-digit input, and then
to select
, and then press
5
--
/
VOLUME
on the TV can be pressed to turn
POWER on the TV set.
/ on the remote control.
CH
16
/ CH . See .
.
1-
15
PAL
B/G
10
E 8