Connections; Connecting To An Antenna; Connecting To An Antenna Via A Vcr - Sharp 20AG2-SMK3 Operation Manual

Connections

Connecting to an antenna

To enjoy a clearer picture, use an outdoor antenna. The following is a brief explanation of
the types of connections that are used for coaxial and feeder cables.

Connecting to an antenna via a VCR

You can also connect the TV set to the tuner on a VCR using the connection shown below.
To antenna in
terminal
• When using the RF terminal connection, set the TV to channel zero to make initial adjustments for the VCR.
• Turn off the power on the TV set and the VCR being connected before making the above connections.
Be sure the cord plugs are fully inserted in the connection terminals.
• See the operation manual of your VCR for connection details.
If your outdoor antenna uses a 75-ohm coaxial cable with a standard
DIN45325 plug (IEC 169-2), plug it into the antenna jack at the rear of
the set.
If your outdoor antenna uses a 300-ohm twin-lead flat feeder, connect a
300-ohm to 75-ohm impedance converter and plug it into the antenna
jack at the rear of the set.
Standard DIN45325 plug (IEC169-2)
75-ohm coaxial cable (round cable) (not supplied)
300-ohm twin-lead 75-ohm impedance
flat feeder converter
(not supplied) (not supplied)
VCR
TV
Antenna in
TV
To RF out
terminal Antenna in
E 22