Sharp 14AG2-DC Operation Manual page 9

Basic Operation (continued)
(3) Changing the Channels
Changing channels with the CHANNEL UP (CHr) or DOWN (CHs) button on the remote control
Press the CHANNEL UP (CHr) button and the channels change in the order shown below:
1 → 2 → 3 → ... → 98 → 99 → 0 → 1 → 2 → 3 → ...
Press the CHANNEL DOWN (CHs) button and the channels change in the order shown below:
3 → 2 → 1 → 0 → 99 → 98 → ... → 3 → 2 → 1 → ...
• Channels that have been set to SKIP cannot be selected. (Please see page 12 for details on Skipping Channels.)
• When selecting the channel using the CHANNEL UP (CHr) or DOWN (CHs) button on the TV set, AV mode is
positioned as follows:
Channel up: 1 → 2 → 3 → ... → 98 → 99 → AV → 0 → 1 → 2 → 3 → ...
Channel down: 3 → 2 → 1 → 0 → AV → 99 → 98 → ... → 3 → 2 → 1 → ...
Changing channels using the CHANNEL SELECT buttons on the remote control
• To handle the increasing number of channels available, this TV set allows you to select up to 100
position (Channel 0 to 99). One-digit and two-digit methods of selection can be used. Follow the
procedure shown below to select channels.
4
5
7
8
0
CH
CH
1
2
4 5
7
8
0
CH
CH
(4) Adjusting the Volume
CH
CH
FUNCTION TIMER PICTURE
(TV set)
8
To select a one-digit channel (e.g.,
6
Channel 5):
9
(1) Press the
(2) If "5-" is indicated and the picture
does not change, press the
to switch over to the 1-digit select
mode and press the
To select a two-digit channel (e.g.,
3
Channel 15):
6
(1) Press the
select mode.
9
(2) Press the
(3) Press the
• In this mode entering a 0 first will
enable selection of single digit
channels e.g. 07.
• Complete this procedure within 6
seconds, otherwise the selection will
not be made.
Press the VOLUME UP ( ) or
DOWN ( ) button to adjust the
volume.
The number of oval blocks " "
indicates volume level.
The display disappears approximately
3 seconds after the volume adjustment
has been completed.
button.
5
button
button again.
5
button to set the 2-digit
button.
1
button.
5
5
PAL
B/G
- -
1 -
1 5
P A L
B / G