Sharp 14AG2-DC Operation Manual page 8

Basic Operation (continued)
(2) Battery Operation
Turn on the DC Power
L
Connect the red battery clip
to (+) on the battery terminal.
@
POWER
indicator
TV/VIDEO
@
1
2
TV/VIDEO
4
5
1
7 2 8
4 5
0
7
8
0
• This set can only be used for a 12V car battery. Do not use for a 24V battery.
• Battery voltage will turn to DC POWER OFF for protection when it reaches below 11V.
• Power will not turn on even if the battery indicator appears red when the voltage is below 11V.
• When not using the battery, remove the battery clip to avoid battery drain.
• Battery power is disabled while using AC power.
• Wipe any dirt from the battery terminal completely before connecting.
• Do not place any object (such as an antenna rod) besides the battery clip near the battery terminal.
• If you connect both the battery and AC power, AC power will have priority. In case of power failure, it automati-
cally switches to DC power. As soon as AC power recovers, it will switch back to AC power.
• The operating time of the battery varies with the type, brightness and volume. 75AH battery can last for about
10 hours after a full charge.
• Colour shading may occur while using the DC battery. In such case, turn on the power using the AC power and
then switch to DC power.
RED
!
Press the DC Power. The battery indicator will appear green.
If the indicator appears red, battery voltage is low. The
battery needs recharging.
!
@
Press the STANDBY/ON (B) button on the remote control or any
of the CHANNEL UP (CHr) or DOWN (CHs) button on the TV
set.
The POWER indicator changes from Dark red to Red and a
picture appears on the screen.
3
DC power switch/ Battery Indicator
Green: Battery Operation mode
6
Red:
3 9
6
9
BLACK
12V
Battery charge warning mode
Connect the black battery clip
to (–) on the battery terminal.
12V CAR BATTERY
7