Sharp WF-5000W Operation Manual page 8

System connections (continued)
WF-5000W
ENGLISH
AC 110V AC 220V
- 127V - 240V
VOLTAGE
SELECTOR
AC 110V AC 220V
- 127V - 240V
VOLTAGE
SELECTOR
110-127/220-240 V
50/60 Hz
Setting the AC voltage selector
Check the setting of the AC voltage selector located on the rear panel before
plugging the unit into a wall socket. If necessary, adjust the selector to corre-
spond to the AC power voltage used in your area.
Selector adjustment:
Slide the selector with a screwdriver to the appropriate voltage number (AC
110 - 127 V or AC 220 - 240 V).
E-7
AC power connection
After checking all the connections have been made correctly, plug the AC
power lead of this unit into the wall socket. If you plug the unit first, the unit will
enter the demonstration mode.
Notes:
The unit will start the tape initialisation when plugged in to the wall socket.
During this process, initialising sound will be heard and the unit cannot be
turned on. Wait until the process is finished.
Unplug the AC power lead from the wall socket if the unit will not be in use
for a prolonged period of time.
Demonstration mode
The first time the unit is plugged in, the unit will
enter the demonstration mode. You will see
words scroll.
To cancel the demonstration mode:
When the unit is in the power stand-by
To the wall socket
mode (demonstration mode), press
the SIMBA MODE/DEMO button. The
demonstration mode will be cancelled
and the display will disappear.
To return to the demonstration mode:
When the unit is in the power stand-by mode, press the SIMBA MODE/DEMO
button again.
Notes:
When the power is on, the SIMBA MODE/DEMO button can be used to
select the simba mode.
Demonstration mode will not be displayed when DC Adaptor is connected
or when battery is in use.
06/3/21 WF-5000W(U)2.fm
TINSEA095AWZZ