Tape Record Pause Button - Sharp WF-5000W Operation Manual

Recording from the radio
1
Tune in to the desired station. (See page 12.)
2
Load a cassette into the TAPE 2 cassette compartment with the
side A facing you.
Wind past the leader of the tape, on which recording cannot be per-
formed.
ƒ button to choose one side or both sides. ƒ
3 Press the ƒ ƒ
© ... To record on both sides.
é ... To record on only one side.
4
Press the button.
Recording will be paused.
5
Press the button to record on side A, or the
mote control for side B.
To record on both sides, begin with side A. (If recording is started from
side B, the tape will not switch over to side A.)
To interrupt recording:
Press the button.
To resume recording, press the same recording button you pressed in step 5.
Other buttons do not allow resuming.
To stop recording:
Press the button.
Beat cancel switch:
If a whistling noise occurs when recording from an MW, SW1 or SW2 station,
set the BEAT CANCEL switch to A, B or C, whichever gives the best reception.
Recording from the built in microphone
1
Press the TAPE (1
2
Load a cassette into the TAPE 2 cassette compartment.
Press the ƒ ƒ button to choose one side or both sides. ƒ ƒ
3
© ... To record on both sides.
é ... To record on only one side.
4
Press the button.
Recording will be paused.
5
Press the button again to begin recording on side A or
for side B.
Notes:
Do not connect anything to the Mixing Mic socket.
Monitoring of the recording is not possible.
Recording from the built-in microphone is not in stereo.
button on the re-
Mixing recording from microphone and tape
1
Connect the microphone plug to the Mixing Mic socket.
2
Press the TAPE 1 function.
3
Load a blank tape into the TAPE 2 cassette compartment. Insert a
pre-recorded cassette into the TAPE 1 cassette compartment.
4
Press the button.
5
Press the button of TAPE 1.
Notes:
Place the microphone about 10-15 cm (4-6") away from the source.
If the howling occurs, lower the volume or move the microphone as far as
possible from the speaker.
To record the microphone signals only, load a cassette into the
TAPE 2 cassette compartment, set the FUNCTION to TAPE 2.
Press the button and then press the TAPE 2
Caution:
When not using the microphone, remove the microphone plug from the Mixing
Mic socket.
06/2/24
2) button until TAPE 2 appears on the display.
button.
WF-5000W(U)3.fm
TINSEA095AWZZ
WF-5000W
ENGLISH
button
E-16