Specifications - Sharp WF-1100W MK2 Operation Manual

Specifications

As part of our policy of continuous improvement, SHARP reserves
the right to make design and specification changes for product
improvement without prior notice. The performance specification
figures indicated are nominal values of production units. There may
be some deviations from these values in individual units.
General
Power source AC 110 - 127/220 - 240 V ~ 50/60 Hz
DC 15 V
10
Power consumption 32 W
Output power PMPO: 200 W (Total) (AC operation)
MPO: 50 W (25 W + 25 W) (AC operation,
10% T.H.D)
RMS: 25 W (12.5 W + 12.5 W)
(AC operation,10% T.H.D)
Output terminal Headphones: 16 - 50 ohms (recommended:
32 ohms)
Input terminals Mixing Microphone: 600 ohms
AUX IN: 350 mV/47 kohms
Dimensions Width: 300 mm (11-13/16")
Height: 240 mm (9-29/64")
Depth: 220 mm (8-11/16")
Weight 3.9 kg (8.6 lbs.) without batteries
Speaker section
Type 2-way type
Speakers 12 cm (4-3/4") Free-edge + Piezo
Speaker x 2
Maximum input 25 W
power
Rated input power 12.5 W
Impedance 6 ohms
Dimensions Width: 235 mm (9-1/4")
Height: 262 mm (10-5/16")
Depth: 220 mm (8-11/16")
Weight 1.6 kg (3.5 lbs.)/each
...
, (UM/SUM-1, HP-2 or R20) x
Radio
Frequency range FM: 88 - 108 MHz
SW1: 2.3 - 7.3 MHz
SW2: 7.3 - 22 MHz
MW: 540 - 1600 kHz
Tape recorder
Frequency response 60 - 10,000 Hz (Normal tape)
Signal/noise ratio 40 dB
Wow and flutter 0.15% (WRMS)
Motor DC 9 V electric governor
Bias system AC bias
Erase system Magnet erase
WF-1100W
MK2
ENGLISH
E-16