Connecting The Device To Your Pc And Installing The Usb Drivers - Sharp Qtopia Desktop Operation Manual

2
BEFORE YOU BEGIN
• 64MB RAM for Microsoft
with SP6/ 2000 Professional/Me
128MB RAM for Microsoft
• CD-ROM Drive
• 1 Available USB Port or Serial Port with Optional Serial Cable CE-170TS
• Mouse or Compatible Pointing Device
* Optional Serial Cable CE-170TS is necessary with Windows NT  4.0 Workstation with SP6 to use this
software.
Connecting the Device to Your PC and
Installing the USB Drivers
To transfer data between the device and your PC using the Docking Station (USB
cable), install the USB drivers found in the CD-ROM supplied.
Check the Drivers installation manual ("USB DRIVER INSTALLATION GUIDE").
Note: Refer to the device Start-up Guide (booklet) for connection details.
About the USB port
• If the USB port on your PC or the USB hub connected to the device does not
operate properly, perform the following steps.
• When your PC comes equipped with several USB ports, connect the device to
another USB port.
• When other USB devices are connected to your PC and used simultaneously,
disconnect them from your PC.
• Operation on a PC that is upgraded from Windows 95 may not be possible.
• A PC whose USB port is added by the user because the PC is not equipped with
a USB port at the time it leaves the factory may not operate properly.
• Activating the power saving mode (suspend, resume, or sleep function etc.) of
some PCs may result in the USB port not functioning properly. In this case,
disable the power saving mode.
• If the USB driver does not operate properly when you connect the device to your
PC via the USB hub, connect it directly to the USB port on your PC. Using the
USB extension cable may result in the USB driver not operating properly.
 
Windows 98/98 Second Edition/NT 4.0 Workstation
 
Windows XP