Recording To A Cassette Tape; Recording From The Radio - Sharp QT-80W Operation Manual

Recording to a Cassette Tape

Before recording:
When recording important selections, make
a preliminary test to ensure that the desired
material is properly recorded.
SHARP is not liable for damage or loss of
your recording arising from malfunction of
this unit.

Recording from the radio

1
Set the FUNCTION switch to RADIO.
2
Set the BAND SELECTOR switch to FM,
MW, SW1 or SW2.
3
Tune in to the station to be recorded.
4
Load a blank cassette into the cassette
compartment with the side to be record-
ed on facing up.
5
Press the PAUSE 6 6 6 6 6 button.
6
Press the RECORD
7
Press the PAUSE 6 6 6 6 6 button again to be-
gin recording.
To stop recording:
Press the STOP/EJECT
Beat cancel switch:
If a whistling noise occurs when recording from
an MW, SW1 or SW2 station, set the BEAT
CANCEL switch to A or B, whichever gives the
best reception.
01-E1-E9-QT-80W(S)
The ALC (Automatic Record Level Control)
circuit automatically controls the level of the
input signal used for recording.
The VOLUME and X-BASS controls may be
adjusted with no effect on the recorded sig-
nal. (Variable Sound Monitor)
Metal and CrO
recording.
Recording from the built-in
microphone
1
Set the FUNCTION switch to TAPE.
2
Load a cassette into the cassette com-
partment.
3
Press the PAUSE 6 6 6 6 6 button.
4
Press the RECORD
5
Press the PAUSE 6 6 6 6 6 button again to be-
gin recording.
Notes:
button.
Monitoring of the recording is not possible.
Recording from the built-in microphone is
not in stereo.
Erasing a recorded tape
7 button.
1
Set the FUNCTION switch to LINE.
Do not connect anything to the LINE IN and
MIXING MIC sockets.
2
Load a tape into the cassette compart-
ment with the side to be erased facing up.
3
Press the RECORD
E-6
7
tapes cannot be used for
2
button.
button.
01.9.19, 15:28