Recording On A Cassette Tape; Recording From The Radio - Sharp QT-222W Operation Manual

Recording on a Cassette Tape

Before recording:
G When recording important selections, make
a preliminary test to ensure that the desired
material is properly recorded.
G SHARP is not liable for damage or loss of
your recording arising from malfunction of
this unit.
STAND-BY
I Recording from the radio
1
Set the FUNCTION switch to RADIO.
2
Set the BAND SELECTOR switch to FM,
MW, SW1 or SW2.
3
Tune in to the station to be recorded.
4
Load a blank cassette into the cassette
compartment with the side to be record-
ed on facing you.
5
Press the PAUSE 6 6 6 6 6 button.
6
Press the RECORD G button.
7
Press the PAUSE 6 6 6 6 6 button again to be-
gin recording.
To stop recording:
Press the STOP/EJECT I 7 button.
QT-222W(B)_E.pm
G The ALC (Automatic Record Level Control)
circuit automatically controls the level of the
input signal used for recording.
G The VOLUME control may be adjusted with
no effect on the recorded signal. (Variable
Sound Monitor)
G Metal and CrO
recording.
I Recording from the built-in
microphone
1
Set the FUNCTION switch to TAPE.
2
Load a cassette into the cassette com-
partment.
3
Press the PAUSE 6 6 6 6 6 button.
4
Press the RECORD G button.
5
Press the PAUSE 6 6 6 6 6 button again to be-
gin recording.
Note:
G Monitoring of the recording is not possible.
E-5
12
tapes cannot be used for
2
03.10.24, 11:55 AM
QT-222W(B) 92L20101550040