Operation With Batteries; Listening To The Radio - Sharp QT-222W Operation Manual

Operation with Batteries

1
Disconnect the AC power lead, and re-
move the battery compartment cover.
2
Insert 4 "D" size batteries (UM/SUM-1,
R20, HP-2 or similar) into the battery
compartment.
G Insert the batteries according to the direc-
tion indicated on the rear panel.
G When inserting or removing the batter-
ies, push them toward the ë battery ter-
minals.
G Installing the batteries incorrectly may
cause the unit to malfunction.
3
Replace the battery compartment cover.
Battery replacement:
Replace the batteries when they become weak

Listening to the Radio

STAND-BY
1
Set the FUNCTION switch to RADIO.
2
Set the BAND SELECTOR switch to FM,
MW, SW1 or SW2.
3
Turn the TUNING control to tune in to the
desired station. The FINE TUNING con-
trol functions only for SW1 and SW2
bands.
4
Turn the VOLUME control to increase or
decrease the volume.
QT-222W(B)_E.pm
1
2
4
and/or recording or playback is impaired. This
may occur even though radio broadcasts are au-
dible.
Notes:
G Replace all old batteries with new ones at
the same time.
G Do not mix old and new batteries.
G Remove the batteries if they are weak or if
the unit will not be used for long periods of
time. This will prevent potential damage due
to battery leakage.
G Batteries are not included.
Caution:
Do not use rechargeable batteries (nickel-cad-
mium battery, etc.).
Aerial adjustment:
FM
After use:
Set the FUNCTION switch to STAND-BY.
E-3
10
To remove the
batteries:
3
MW
SW1 and SW2
03.10.24, 11:55 AM
QT-222W(B) 92L20101550040