Using The Remote Control (Not Supplied) - Sharp ViewCam VL-AH131S Operation Manual

Using the Remote Control
(Not supplied)
The remote control (RRMCG0084TASA) is not
supplied with this VIEWCAM. Contact the
nearest SHARP service centre or your dealer
for purchasing as a specified part.
Installing the Batteries in the Remote
Control
1
Open the battery compartment cover.
2
Insert the two commercially available AA
(R6 or UM/SUM-3) batteries with the
battery poles positioned as indicated.
1
3
Replace the cover.
Caution:
• Do not use old and new batteries together or
batteries of different brands together.
Turning On the Remote Control Mode
1
Press the MENU button until
(VCR mode).
2
Press the or
"REMOTE", then press the SET button
(B) (W) to select "ON" .
S E T
3
Press the DISPLAY button to turn off the
menu screen.
2
appears
button (Q) to select
MENU
ED I T OF F
AUTO
REMOT E ON
P I C -
S E T TURE
Operating the Remote Control
Aim the remote control at the remote sensor of
the VIEWCAM, and press the control buttons for
operation.
Remote sensor
Approximate operating
range of remote control
REWind/Reverse Search button
RECord START/STOP button
VOLUME buttons
PAUSE/STILL button
Notes:
• Be careful not to allow direct sunlight or bright
light from interior illumination to fall onto the
VIEWCAM remote sensor, as this may prevent
the remote control from operating properly.
• Be sure that there are no obstacles between the
remote control and the VIEWCAM remote sensor.
• The remote control cannot be used to move the
pointer, or select or set any of the various
functions on the monitor.
• When the batteries are depleted and the remote
control does not operate, replace them with new
AA (R6 or UM/SUM-3) batteries.
• You can also turn on the Remote Control mode
on the (MENU 1) screen in Camera mode.
Power Zoom Telephoto/
Wide angle control
buttons
Fast Forward/
Forward Search button
SLOW button
PLAY button
STOP button
40