Listening To The Radio - Sharp XL-MP100H Operation Manual

Listening to the radio

1
Press the ON/STAND-BY button to turn the power on.
2
Press the FUNCTION button until "FM" or "AM" appears on
the display.
When operating with the remote control, press the TUNER
(BAND) button to select "FM" or "AM".
3
Press the TUNING ( or ) button to tune in to the desired
station.
Manual tuning:
Press the TUNING button as many times as required to tune in
to the desired station.
Auto tuning:
When the TUNING button is pressed for more than 0.5 sec-
onds, scanning will start automatically and the tuner will stop at
the first receivable broadcast station.
Notes:
" When radio interference occurs, auto scan tuning may stop auto-
matically at that point.
" Auto scan tuning will skip weak signal stations.
" To stop the auto tuning, press the TUNING button again.
" When an RDS (Radio Data System) station is tuned in, the fre-
quency will be displayed first, and then the RDS indicator will
light. Finally, the station name will appear.
" Full auto tuning can be achieved for RDS stations "ASPM", see
page 23.
" This product can receive FM stereo/FM monaural and AM mon-
aural broadcasts. AM stereo broadcasts will not be played in ste-
reo.
To receive an FM stereo transmission:
Press the FUNCTION [TUNER (BAND)] button to display the "ST"
indicator.
" " " will appear when an FM broadcast is in stereo.
" If the FM reception is weak, press the FUNCTION [TUNER
(BAND)] button to extinguish the "ST" indicator. The reception
changes to monaural, and the sound becomes clearer.
FM stereo mode indicator
FM stereo receiving indicator
04/1/28 XL-MP100H(A)2.fm
XL-MP100H
5
17
TINSEA014SJZZ