Table of Contents
Advertisement
Other Setup Options
■ Projection
Settings > Projection
You can select different options for projecting the image:
Rear/Ceiling
■ Standby Mode (PowerLite Pro Cinema 61000 only)
Settings > Operation > Standby Mode
Select
Communication On
when the projector is in standby mode.
■ Direct Power On
Settings > Operation > Direct Power On
Sets projection to start when the main power switch is turned on, without pressing the
P power button on the remote control or the projector.
Note: When Direct Power On is enabled, restoration of power after a power outage can cause
the projector to turn on.
■ Video Signal
Settings > Input Signal > Video Signal
Leave this setting on
NTSC or PAL (for standard TV formats).
■ Component
Settings > Input Signal > Component
Change this setting to match the type of equipment connected to the Component port.
For component video, select
or select
■ HDMI1 EQ Setting
HDMI2 EQ Setting
Settings > Input Signal > HDMI1 EQ Setting or HDMI2 EQ Setting
If you're using a long HDMI cable, you may have to select a higher setting to increase the
projector's sensitivity to the incoming signal. You can select a separate setting for each of
the projector's HDMI ports.
44
Making Detailed Adjustments
.
to monitor and control the projector over your network
so the projector can automatically interpret the format, such as
Auto
Auto
or
to manually select your video equipment's signal.
YCbCr
YPbPr
to let the projector automatically interpret the signal;
,
Front
Front/Ceiling
,
,
Rear
Advertisement
Table of Contents
