Connections To The Mac-200; To Re-Close The Cover - SGC MAC-200 Operating Manual

In order to open the MAC-200 to get at the JP1 or JP3 jumpers or
to visually inspect the circuit boards, you need to do the following:

To re-close the cover:

1. Orient the cover so
that the small groove
for the locking
washer is at the back
of the MAC-200
2. Engage the cover
with the body of the
MAC-200 from the
front or the back and
slide it into place.
3. Holding the MAC-200 with the back panel UP, push
the washer into the slot engaging the cover slot and
drive the screw into the hole until tight.

3.2 Connections to the MAC-200

PO Box 3526, Bellevue, WA. 98009 13737 SE 26
Toll Free: 800-259-7331 * Phone: 425-746-6310 * Fax: 425-746-6384
© 2003 SGC Inc.
www.sgcworld.com * Email: sgc@sgcworld.com
1. Loosen the cover lock
on the back panel of the
MAC-200 until the
washer disengages from
the MAC-200 cover.
2. Slide the cover forwards
or backwards until it
disengages from the rail.
th
St. Bellevue, WA. 98005
8