Setting The Initial Configuration; Logging Into A Switch - HP StorageWorks 8B - FC Entry Switch Manual

Fabric os procedures guide (version 3.0)

Hide thumbs Also See for StorageWorks 8B - FC Entry Switch:

Table of Contents

Setting the Initial Configuration

This chapter provides information on initial configuration tasks for a switch.

To log into a switch:

Open a telnet connection to the switch. The login prompt is displayed if the telnet connection

successfully found the switch in the network.

Note:

At the login prompt enter the user ID you are logging in as. For example:

The password prompt is displayed if the user exists.

Enter the password for the user:

password: xxxxxx

The default password is password.

If the login was successful a prompt is displayed showing the switch name and user ID you are

logged in as. For example:

switch55>admin:

Fabric OS Procedures Guide

The switch must be connected to your IP network through the RS-232 port to enable

connection through telnet. Refer to the hardware manual of your switch for more

information about connecting the switch to your IP network.

Chapter

1-1

Table of Contents

Do you have a question about the StorageWorks 8B - FC Entry Switch and is the answer not in the manual?