Grounding Instructions - Electrolux TINSLB003MRR0 Use & Care Manual

Hide thumbs Also See for TINSLB003MRR0:
Table of Contents

Advertisement

GROUNDING
iNSTRUCTiONS
This appliance must be grounded. This oven is equipped with a cord having a grounding wire with a ground-
ing plug. It must be plugged into a wall receptacle that is properly installed and grounded in accordance
with the National Electrical Code and local codes and ordinances.
In the event of an electrical short circuit,
grounding reduces risk of electric shock by providing an escape wire for the electric current.
Improper use of the grounding
plug can result in a risk of electric shock.
Electrical
Requirements
The electrical
requirements
are a 120 volt 60 Hz, AC only, 15 amp. or
more protected electrical
supply. It is recommended
that a separate
circuit serving only this appliance be provided.
The oven isequipped with a 3-prong grounding plug. It must be plugged
into a wall receptacle that is properly installed and grounded. Should
you only have a 2-prong outlet, have a qualified electrician
install a
correct wall receptacle.
A 3-prong adapter
may be purchased
and used temporarily
if local
codes allow. Follow package directions.
A short power-supply
cord is provided
to reduce risk of becoming
entangled in or tripping over a longer cord. DO NOT USE AN EXTENSION
CORD. If the power supply cord is too short, have a qualified electrician
or serviceperson
install an outlet near the appliance.
NOTES:
1. If you have any questions about the grounding or electrical instruc-
tions, consult a qualified electrician or serviceperson.
2. Neither Electrolux nor the dealer can accept any liability for damage
to the oven or personal injury resulting from failure to observe the
correct electrical connection
procedures.
Permanent and Correct installation
3-Prong
Plug
Grounding
Pin
_
!_j
3=Prong
Receptacle
Ground
/
Receptacle
Box
Temporary Use
Ground
Grounding
Receptacle
Box
Adapter
Screw_
Tab for /
L_
tl
Grounding
Screw
_1
Radio or TV interference
Should there be any interference
caused by the microwave oven to your radio or TV, check that the
microwave oven is on a different electrical circuit, relocate the radio or TV as far away from the oven as
feasible or check position and signal of receiving antenna.

Advertisement

Table of Contents
loading

Table of Contents