Solutions - Electrolux Gas Slide in Range Use & Care Manual

Solutions to Common Problems
OVEN SMOKES EXCESSIVELY DURING BRO_UNG
[] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] []
Meat too close to the broiler element. Reposition the rack to provide more clearance between the
meat and the broiler. Preheat broil element for quick searing operation.
Meat not properly prepared. Remove excess fat from meat. Cut remaining fatty edges to prevent
curling, but do not cut into the lean.
Grid on broiler pan wrong side-up. Grease does not drain into broiler pan. Always place the grid on
the broiler pan with the ribs up and the slots down to allow grease to drip into the pan.
Broiler pan used without grid or grid cover with aluminum foil. DO NOT use the broiler pan without
the grid or cover the grid with aluminum foil.
Oven needs to be cleaned. Grease has built up on oven surfaces. Regular cleaning is necessary
when broiling frequently. Grease or food spatters cause excessive smoking.
SO_LNOT COMPLETELY REMOVEDAFTER SELFoCLEAN_NGCYCLE IS COMPLETED
[] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] []
Failure to clean bottom, from top of oven, frame of oven or door area outside oven seal. These
areas are not in the self-cleaning area, but get hot enough to burn on residue. Clean these areas
before the self-cleaning cycle is started. Burned on residue can be cleaned with a stiff nylon brush
and water or a nylon scrubber. Be careful not to damage the oven gasket.
Excessive spitlovers in oven. Set the self-clean cycle for longer cleaning time.
SURFACE
[]
®
BURNERS DO NOT UGHT
[] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] []
Surface Control knob has not been completely turned to LITE. Push in and turn the Surface
Control knob to LITE until burner ignites and then turn control knob to desired flame size.
• Be sure gas supply valve is open.
, Burner ports are clogged. Clean burners. See Cleaning the Burner Grates, Burner Caps,
Burner Heads in General Care & Cleaning section. With the burner off, clean ports with a small-
gauge wire or needle.
Power cord is disconnected from outlet (Electric Ignition Models only). Be sure cord is securely
plugged into the outlet.
Electrical power outage (electric ignition models only). Burners can be lit manually. See Setting
Surface Centrels in this Use and Care Guide.
BURNER FLAME ONLY UGHTS HALF WAYAROUND BURNER
[] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] []
• Burner ports are clogged. With the burner off, clean ports by using a small-gauge wire or needle.
• Moisture is present after cleaning. Lightly fan the flame and allow burner to operate until flame is
full. Dry the burners thoroughly following instructions in the General Cleaning section.
FOOD NOT HEATING EVENLY
[] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] []
, Improper cookware. Select flat-bottomed cookware of a proper size to fit element.
, Incorrect control setting. Raise or lower setting until proper amount of heat is obtained.
[] []
BURNER FLAME iS ORANGE
[] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] []
Dust particles in main line. Allow the burner to operate a few minutes until flame turns blue.
In coastal areas, a slightly orange flame is unavoidable due to salt air.Ceramic-Glass Ceektop
section in this Owner's Guide.
Cookware with rough bottom has been used. Use flat-bottomed, smooth utensils. See Selecting
Surface Ceoking Utensils in this Owner's Guide.