•
Make certain pump is mounted and aligned
properly.
•
Use a flexible "spider" type coupling between
engine and pump drive shafts.
•
Keep hoses clear and unblocked.
•
Bleed air out of hoses before operating.
•
Flush and clean hydraulic system before start-
up after any malfunction or servicing.
•
Use "pipe dope" on all hydraulic fittings.
•
Allow time for warm-up before splittingwood,
•
Prime the pump before initialstart-up by turning
over the engine with spark plug disconnected.
•
Split wood with the grain (lengthwise) only.
Never:
•
Use when fluid is below 20 ° F, or above 150° F,
•
Use a solid engine/pump coupling.
•
Force pump when mounting.
•
Operate through relief valve.
•
Attempt to adjust unloading or relief valve.
settings without pressure gauges.
•
Operate with air in hydraulic system.
•
Use Teflon tape on hydraulicfittings.
•
Attempt to cut wood across the grain,