Product View And Parts Identification; Assembly; Install And Adjust The D-Handle; Installing The Trimmer Attachment - Craftsman Incredi-Pull 316.791860 Operator's Manual

CRAFTSMAN FU LL WAR RANTY
If this Craftsman product fails due to a defect in material or workmanship within two years from the date of purchase, return it to any Sears
store, Parts & Repair Service Center, or other Craftsman outlet in the United States for free repair (or replacement if repair proves impossible).
This warranty applies for only 90 days from the purchase date if this product is ever used for commercial or rental purposes.
This warranty covers ONLY defects in material and workmanship. Sears will NOT pay for:
• Expendable items that can wear out from normal use within the warranty period, such as cutting line, filters or spark plugs.
• Repairs necessary because of accident or failure to operate or maintain the product according to all supplied instructions.
• Preventive maintenance, or repairs necessary due to improper fuel mixture, contaminated or stale fuel.
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
Sears, Roebuck and Co., Hoffman Estates, IL 60179
On/Off Stop Control
Fuel Cap Starter
Rope Grip
Shaft Grip
APPLICATIONS
As a trimmer:
• Cutting grass and light weeds.
Edging
Decorative trimming around trees, fences, etc.
Other optional accessories may be used with this unit.
Throttle Control
D-Handle
Spark Plug
Air Filter/ Shaft Housing
Muffler Cover
Convertible
TM
Primer Bulb Coupler
Trimmer
Muffler Attachment
Line g
Blade
Trimmer Shield
Hassle Free ® Cutting d
INSTALL AND ADJUST THE D-HANDLE
1. Push the D-handle down Shaft Grip
onto the shaft housing so
that the handle slants
towards the shaft grip Tighten
(Fig. 1). The squared bolt
hole in the handle is to Minimum 6 in.
the right. (15.24 cm) Wing
2. Insert the shoulder bolt Nut
into the squared hole in
the handle and push Bolt Washer
through. On the left side Fig. 1
of the handle, place the
washer on the bolt, then screw the wing nut onto the bolt. Do
not tighten until you make the handle adjustment.
D=Handle
3. Rotate the D-handle to place the grip above the top of the shaft
housing. Place it a minimum of 6 inches (15.24 cm) from the
end of the shaft grip.
4. While holding the unit in the operating position
(Fig. 8), position the D-handle to the location that provides you
the best grip.
5. Tighten the wing nut until the D-handle is secure.
INSTALLING THE TRIMMER ATTACHMENT
Prior to use, make sure trimmer attachment is installed correctly.
Please refer to Operating the Convertible
TM
Coupler System for
proper installation.
NOTE: Remove red cap or hanger from lower shaft housing prior to
assembling to Convertible
TM
coupler