Advertisement
S
AND ADJ USTMENT
POSITIVE TERMINAL
NEGATIVE TERMINAL
CABLES
CHARGED
BATTERY
POSITIVE TERMINAL
NEGATIVE TERMINAL
FIG. 31
TO REPLACE
HEADLIGHT
BULB
-
Raise hood.
•
Pull bulb holder out of the hole in the backside of the
grill.
•
Replace bulb in holder and push butb holder securely
back into the hole in the backside of the grill°
•
Close hood.
INTERLOCKS
AND RELAYS
Loose or damaged widng may cause your tractor to run
poorly, stop running, or prevent it from starting.
°
Check wiring.
See electrical wiring diagram in the
Repair Parts section of this manual.
TO REPLACE
FUSE
Replace with 30 amp automotive-type plug-in fuse. The
fuse holder is located behind the dash.
TO REMOVE
HOOD AND GRILL ASSEMBLY
(See Fig. 32)
-
Raise hood_
•
Unsnap headlight wire connector.
•
Stand in front of tractor. Grasp hood at sides, tilttoward
engine and lift off of tractor,,
°
To replace, reverse above procedures°
__
_._
HOOD
FIG. 32
ENGINE
TO ADJUST THROTTLE
CONTROL
CABLE
(See Fig. 33)
The throttle control has been preset at the factory and
adjustment should not be necessary. Check adjustment as
described below before loosening cable° if adjustment is
necessary, proceed as follows:
-
With engine not running, move throttle control lever
from slow (.If)
to choke (l\l) position.
Slowly move
lever from choke
(1\1)
t o fast (,_) position.
°
Checkthat holes"A" in governor control lever and hole
in governor plate line-up,, tf holes 'A" are not aligned,
loosen clamp screw and move throttle cable until holes
are aligned. Tighten clamp screw securely.
GOVERNOR
GOVERNOR
CONTROL LEVER
CONTROL PLATE
HOLES "A"
CLAMP
THROTTLE
SCREW
CABLE
FIG. 33
25
Advertisement
