Carton Contents; Available Accessories; Unpacking And Checking Carton Contents - Craftsman 183.172521 Owner's Manual

AVAILABLE ACCESSORIES
IA WARNINGJ
Use only accessories recommended for this cutting
tool. Follow instructions that accompany accessories.
Use of improper accessories may cause injury to the
operator or damage to the cutting tool.
Visit your Sears Hardware Department or see the Sears
Power and Hand Tool Catalog for an assortment of
accessories recommended for use with this cutting tool:
• Flex Drive
• Rip Guide
• 1/8"Cutting Bits
• 1/8"Hobby Rotary Tool Accessories
>. Cutters
> Polishers
Sanders
Grinders
• Most ¼" Shank Router Bits
IA WARNINGI
Use only accessories designed for this cutting tool to
avoid severe injury or tool damage.
Do not use any accessory unless you have completely
read the instructions or Owner's Manual for that
accessory.
UNPACKING AND CHECKING CARTON CONTENTS
[,_, WARNING]
If any part is missing or damaged, do not plug the
cutting tool into the power source until the missing
damaged part is replaced and assembly is complet,
Carefully unpack the cutting tool and all its components
Compare against the "Cutting Tool Components" chart
below.
NOTE: See Page 7 for illustration of components.
I_, WARNING I
To avoid fire or toxic reaction, never use gasoline,
naphtha, acetone, lacquer thinner or similar highly
volatile solvents to clean the cutting toot.
CUTTING TOOL COMPONENTS
KEY _ DESCRIPTION
Inside Carrying Case
icu oo,
B Precision Handle with Sole Plate 11
Freehand Sole Plate Attachment
Circle Cutter Attachment
Circle Cutter Installation Adapter
Plunge Router Base Attachment
i i
Carryin 9 Case
Collet Wrench
Collet Wrench Holder
Front Lid Storage Compartment
I I 1/8" Collet Sleeve I 1
J I 1/4" Collet Sleeve 1
K Lateral Style Drywall Cutter I 1
L Wood / Past c / F berg ass Cutter 1
NOTE: The two most commonly used cutters are
included with this tool (items K & L). It is important
that you usa the correct cutter to ensure the most
efficient cutting action.
• Use cutter "K" with the coarser spiral for cuttin
drywall.
• Use the general purpose cutter "L" with the fin_
spiral for cutting materials such as wood, plasti
and fiberglass.